To run multiple streams of bpduplicate form the command line, requires running
mulitple bpduplicate commands. You'll have to write a script that splits up
the images list into groupings and then runs a separate bpduplicate command for
each grouping.
Be careful with this however, if you are reading from tape (hopefully not), you
should group them by the Media ID they are on as to prevent a delay in one
stream as it waits for the other to release the tape it's using, just to have
the other then wait for the same tape to be released again, and so on.
+----------------------------------------------------------------------
|This was sent by spaldam AT spaldam DOT com via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|