Yeah I have the command for 5.1MP6 single tape eject, that worked fine.
But once I upgraded even building a proper command using the man page
for vmchange still resulted in nothing. I even had -multi_eject in
there. What ever -single_cycle is it fixed it.

On 09/13/2010 01:51 PM, A Darren Dunham wrote:
> On Mon, Sep 13, 2010 at 01:43:40PM -0500, Nate Sanders wrote:
>   
>> That did it. What is -single_cycle? It's not even in the vmchange man
>> page!! *facepalm*
>>     
> No, it doesn't seem to be documented.
>
> I came across it in a discussion on the Symantec forum.  There used to
> be some other ways of doing it in the pre-6.0 universe (also un- or
> under-documented), but they don't work in modern versions.
> -single_cycle doesn't do exactly the same thing but it works for me.
>
>   

-- 
Nate Sanders            Digital Motorworks
System Administrator      (512) 692 - 1038




This message and any attachments are intended only for the use of the addressee 
and may contain information that is privileged and confidential. If the reader 
of the message is not the intended recipient or an authorized representative of 
the intended recipient, you are hereby notified that any dissemination of this 
communication is strictly prohibited. If you have received this communication 
in error, please notify us immediately by e-mail and delete the message and any 
attachments from your system.
_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu