Dear Forum,

My setup is 6.5.5 on Solaris 10.

When i run sgscan tape it gives few output and then goes in hang state not 
giving any output.

--------------------------------------------------------------------------------
root@P203XMED03 # /opt/openv/volmgr/bin/sgscan tape
#
#WARNING: detected StorEdge Network Foundation connected devices not in
#         SG configuration file:
#
#    Device World Wide Port Name 21000014c320fcf6
#
#    See /usr/openv/volmgr/NetBackup_DeviceConfig_Guide.txt chapter
#    "Special configuration for "Sun StorEdge Network Foundation" HBA/Driver"
#    for information on how to use sg.build and sg.install to
#    configure these devices
#

/dev/sg/c0t0l0: (/dev/rmt/0): "IBM     ULTRIUM-TD3"
/dev/sg/c2t0l0: (/dev/rmt/2): "IBM     ULTRIUM-TD3"
----------------------------------------------------------------------------------

Any suggestions....

+----------------------------------------------------------------------
|This was sent by qureshiumar AT rediffmail DOT com via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------


_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu