On Thu, 18 Mar 2010, A Darren Dunham wrote:
> On Thu, Mar 18, 2010 at 11:16:22AM -0400, Justin Piszcz wrote:
>> Hi,
>>
>> Is there a way to use bpdbjobs to *JUST* list Active Restores?
>> I know you can filter the output. However, if you have 50,000-100,000
>> jobs in the queue, it will be very slow because it has to load all of the
>> jobs and then you parse them. If you had 3 restore jobs, it would be
>> great if you could just have those printed out.
>
> There don't appear to be any filters that apply to bpdbjobs other than
> specific jobids.
>
> As far as I know, you must receive the entire list and then filter. I
> think that's what the GUI is doing.
>
> --
> Darren
> _______________________________________________
> Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
>
Hi,
Thanks for the response-- yep, that is what I was afraid of but good to
get that confirmed.
Justin.
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|