Re: [Veritas-bu] Migrate master server to new hardware
2009-08-23 20:10:45
I would install all the packages like a new install then rsync your
entire nbu install/data from the old server :)
On Fri, Aug 21, 2009 at 10:02 PM,
fredriklindgren<netbackup-forum AT backupcentral DOT com> wrote:
>
> We are about to migrate our NetBackup master server from old hardware to a
> new and at the same time upgrade from SLES9 to SLES10 and do a hostname
> change. The server is a pure master and have no connections to disk or tape.
> It is connected to 5 media servers.
>
> Is there a best practice for these kind of migration? Can it be done with a
> DR?
>
> Did some googling and found a post over at the official Symantec forum that
> Symantec support can not assist in these kind of operations and you should
> contact Syamantec Consulting Service.
>
> These kind of migrations must be done frequently around NetBackup customers
> so I am hoping there are some NetBackup gurus out there that's been through
> this before that could give me some good advices?
>
> Regards
> Fredrik Lindgren
>
> +----------------------------------------------------------------------
> |This was sent by fredrik.lindgren AT rps.police DOT se via Backup Central.
> |Forward SPAM to abuse AT backupcentral DOT com.
> +----------------------------------------------------------------------
>
>
> _______________________________________________
> Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
>
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
|
|