Morning
Ages ago, I configured email notifcation so the subject line had the following header

"NetBackup on Client Name - <NameOfServer> Ended With Status Code 0"

Now, for the life of me, I cannot work out where I am meant to reconfigure this. I am going through nbmail.cmd and I believe I have the right section to amend, and it works, but does not give me the status code or client name.

Reason for this, is it makes my life easier to see the client name / status code in the header, rather than having to open an email.

Any ideas?
Thanks in advance

Regards

Simon

This email (including any attachments) may contain confidential
and/or privileged information or information otherwise protected
from disclosure. If you are not the intended recipient, please
notify the sender immediately, do not copy this message or any
attachments and do not use it for any purpose or disclose its
content to any person, but delete this message and any attachments
from your system. Astrium disclaims any and all liability if this
email transmission was virus corrupted, altered or falsified.
-o-
Astrium Limited, Registered in England and Wales No. 2449259
Registered Office:
Gunnels Wood Road, Stevenage, Hertfordshire, SG1 2AS, England

_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu