Re: [Veritas-bu] drives on HP-UX
2008-11-18 08:15:26
Did you run “insf –e”
after you ran the ioscan? On HP the ioscan will detect the new hardware but
doesn’t create the device files (/dev/rmt/*). You have to run “insf
–e” to install do that. After you’ve done that running
ioscan again will show the hardware paths to the drives associated with the
devices to the device file paths to the drives.
From:
veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of Abhishek Dhingra1
Sent: Tuesday, November 18, 2008
12:15 AM
To:
veritas-bu AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] drives on
HP-UX
Hi All,
Need help on configuring the tape drives on HP-UX media server.
"ioscan -C tape" on HP-UX is showing me the new drives zonned with
the server. But the tpautoconf -t is not showing any drive. I am new to HP-UX.
Please help in getting the drives configured.
Rgds
A D
IBM Global Services, Delhi,
Email : abhishek.dhingra AT in.ibm DOT com
Mobile :
+91-9818675370
---------------------------------- CONFIDENTIALITY NOTICE: This e-mail may contain privileged or confidential information and is for the sole use of the intended recipient(s). If you are not the intended recipient, any disclosure, copying, distribution, or use of the contents of this information is prohibited and may be unlawful. If you have received this electronic transmission in error, please reply immediately to the sender that you have received the message in error, and delete it. Thank you. ----------------------------------
|
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
|
|