Folks,
Anybody
out there using EMC Disk Library as a VTL and has experienced similar?
I
have just installed NetBackup 6.5.2 on Solaris 10 with 2 x EMC DL 4000s and 2 x
Quantum Scalar i2000s.
There
are 4 x Solaris 10 Media Servers that are configured to see dedicated drives
from the DLs and shared drives from the i2000s.
The
sgscan and scan output look okay but when I attempt device configuration
through the NetBackup wizard the DL based drives appear with the following
limitations:
Unable
to determine robot type
Drive
is standalone or in unknown robot
Robot
drive number is unknown
The
DLs have inquiry strings "EMC Disk Library
2.0" which apparently is a Symantec requirement.
Regards,
Paul Esson
Redstor Limited
Direct:
+44 (0) 1224 595381
Mobile: +44 (0)
7766 906514
E-Mail:
paul.esson AT redstor DOT com
Web:
www.redstor.com
REDSTOR LIMITED
Torridon House
73-75 Regent Quay
Aberdeen
UK
AB11 5AR
Disclaimer:
The information
included in this e-mail is of a confidential nature and is intended only for
the addressee. If you are not the intended addressee, any disclosure,
copying or distribution by you is prohibited and may be unlawful.
Disclosure to any party other than the addressee, whether inadvertent or
otherwise is not intended to waive privilege or confidentiality.