Folks,
I have just
installed and configured a 6.5 Master Server on Solaris 10 that is also
clustered using VCS. I have done the OS device configuration and
presented my two tape libraries (6 x LTO-4 drives each) to both nodes in the
cluster and am now ready to do device configuration within NetBackup. The
HA guide suggests this is achieved by running the configuration wizard on each
of the two nodes when it is the active member of the cluster and therefore has
NetBackup running.
My question
refers to the fact that I will use SSO to share the drives between the Master
Sever and a number of Media Servers. I am assuming that when the active
node is node A I share the drives between it and the Media Servers and then
repeat the exercise on node B when it is the active node? I did start to
think that when A is the active node I might have to share with B, but B won’t
have NetBackup running certainly as a Master Server, though it does have the
application installed and is known as a Media Server in the configuration.
Can anyone
straighten me out on this one?
Regards,
Paul Esson
Redstor Limited
Direct:
+44 (0) 1224 595381
Mobile:
+44 (0) 7766 906514
E-Mail:
paul.esson AT redstor DOT com
Web:
www.redstor.com
REDSTOR LIMITED
Torridon House
73-75 Regent Quay
Aberdeen
UK
AB11 5AR
Disclaimer:
The information
included in this e-mail is of a confidential nature and is intended only for
the addressee. If you are not the intended addressee, any disclosure,
copying or distribution by you is prohibited and may be unlawful. Disclosure
to any party other than the addressee, whether inadvertent or otherwise is not
intended to waive privilege or confidentiality.