Folks,
I am in the process of building a
v6.5 Master Server on Solaris 10 in a VCS 5.0 framework. I have done the
basic install and tested the application will failover between the two
nodes. However, I now want to configure a couple of FC attached tape
drives for the catalog backups and am confused as to how to proceed. The
documentation suggests I attach the devices to both nodes and run device
configuration from the active node which means the device host will be the
physical node, but do I make the storage units point to the virtual node name
and/or do I have to do something clever with the EMM to tell it about the
relationship between virtual and physical hosts. There is talk of this in
the documentation under the description “application cluster” but is this what I
have i.e. netbackup as an application in a cluster?
Any guidance much
appreciated.
Regards,
Paul Esson
Redstor
Limited
Direct:
+44 (0) 1224 595381
Mobile:
+44 (0) 7766
906514
E-Mail:
paul.esson AT redstor DOT com
Web:
www.redstor.com
REDSTOR LIMITED
Torridon
House
73-75 Regent
Quay
Aberdeen
UK
AB11
5AR
Disclaimer:
The information
included in this e-mail is of a confidential nature and is intended only for the
addressee. If you are not the intended addressee, any disclosure, copying
or distribution by you is prohibited and may be unlawful. Disclosure to
any party other than the addressee, whether inadvertent or otherwise is not
intended to waive privilege or confidentiality.