I don't use vlteject for this,  I do an eject,  I use the windows gui
and just highlight the media and right click eject.  Not sure what the
equiv would be to use the command line.


Doug Preston
Systems Engineer
Land America Tax and Flood Services
Phone 626-339-5221 Ext 1104
Email  dlpreston AT landam DOT com


------------------------------------------------------------------------
------------
NOTICE: This electronic mail transmission may constitute a communication
that is legally privileged. It is not intended for transmission to, or
receipt by, any unauthorized persons. If you have received this
electronic mail transmission in error, please delete it from your system
without copying it, and notify the sender by reply e-mail, so that our
address record can be corrected.
------------------------------------------------------------------------
------------




-----Original Message-----
From: veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of
Brian.Beaird AT cat DOT com
Sent: Monday, July 23, 2007 9:13 AM
To: veritas-bu AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] Ejecting a recalled vault tape

Does anyone know how you are supposed to re-eject a tape that was
vaulted, recalled, and injected into the library?  If I try to use
vlteject, it just tells me that the media has already been ejected (via
the very first time it was vaulted).  Here's what I've done:

1.) Run vault job to eject tape
2.) Remove tape from library and sent off
3.) Recall tape
4.) Use ./vltinject to reinsert tape into library
5.) Do necessary restore
6.) ??? How to re-eject tape to send back off-site ???

Brian Beaird

_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu

_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu