/proc/scsi/scsi only sees the local SCSI bus.

We're running RHEL3, kernel  2.4.21-40.EL with Qlogic 2300 driver
installed.

Zones look right, but not sure why drive isn't seen.  The tape drive is
a straight FC connect - no backplane in the ADIC (Scalar i2K).  The
server is a Dell with a Xeon, NBU 6.0  MP3, Qlogic 23xx.

Jason

> -----Original Message-----
> From: veritas-bu-bounces at mailman.eng.auburn.edu 
> [mailto:veritas-bu-bounces at mailman.eng.auburn.edu] On Behalf 
> Of Peter DrakeUnderkoffler
> Sent: Wednesday, October 25, 2006 12:39 PM
> To: Brooks, Jason
> Cc: veritas-bu at mailman.eng.auburn.edu
> Subject: Re: [Veritas-bu] Linux Media Server, Adic Library, 
> and Drivers
> 
> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
> 
> what do you see when you...
> 
> cat /proc/scsi/scsi
> 
> If it isn't there, then your O/S isn't seeing the drives, 
> check your zones again.  Also, are you using the included 
> qlogic driver to the kernel (which distro and kernel are you 
> using?)  or have you installed the qlogic Linux drivers?  
> There shouldn't be a "driver" for the LTO3 drives, it should 
> be seen as a SCSI "st" device and the NBU install should set 
> up the SG driver correctly.
> 
> There are also great docs included with NBU for this.
> I would also help when asking questions to supply all the data needed:
> 
> - -O/S version and architecture?
> - -NBU version and MP level?
> - -which qlogic cards?
> 
> Thanks
> Peter
> 
> Peter DrakeUnderkoffler
> Xinupro, LLC
> 617-834-2352
> 
> 
> 
> Brooks, Jason wrote:
> > We're testing a Linux media server now to try and resolve some NDMP 
> > issues.  I have the Media server set up, talking to my 
> Master, fiber 
> > connectivity to a tape drive (properly zoned), but I can't find 
> > drivers.  I've contacted ADIC support, but they've been no 
> help.  I've 
> > found IBM drivers (library contains IBM LTO3s), but they don't work 
> > for fibre attached, just SCSI.  The fibre attached drivers link to 
> > Emulex, but we have QLogic cards.
> >  
> > Now, I'm about at the end of my rope.  Any suggestions?  Contact 
> > Veritas support?  My last hope is to wait on my ADIC Sales 
> Rep's Engineer.
> >  
> > Thanks,
> > Jason
> > 
> > 
> > 
> ----------------------------------------------------------------------
> > --
> > 
> > _______________________________________________
> > Veritas-bu maillist  -  Veritas-bu at mailman.eng.auburn.edu 
> > http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
> -----BEGIN PGP SIGNATURE-----
> Version: GnuPG v1.4.1 (FreeBSD)
> 
> iD8DBQFFP5M1l+lekZRM55oRAgnWAJ427l9vIRPhqHCtWVJaVUfgwY7gNACeOmhd
> 2LeaZXnqQeRnzo7Q8UO+uvo=
> =onCD
> -----END PGP SIGNATURE-----
> _______________________________________________
> Veritas-bu maillist  -  Veritas-bu at mailman.eng.auburn.edu 
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
>