I have two Dell PV 132T on a Sun v240 running Veritas Netbackup 4.5 FP 
7, I used the wizard to configure both robots with no issues, I did not 
have to load any 3rd party drivers on the Sun box.  I am running Solaris 2.9

-Thomas

Tim Hoke wrote:
> FWIW, I have a Dell PV132T in through the built in SNC, the devices 
> are on Lun 4-6.... You might try using sg.build all -mt 15 -ml 7.
>
> HTH
> -Tim
>
> On May 27, 2005, at 11:22 AM, Francisco Puente wrote:
>
>> Hello list,
>> Here my configuration:
>> SunFire 6800
>> ADIC Scalar 100 connected via SCSI, 50 slots, 2 SONYSDX-700C drives.
>> Netbackup 4.5 MP6 and FP6 installed.
>> Solaris 8
>>  
>> We've got a new Dell PV132T LTO2 robot to be added, with 2 drives and 
>> 24 slots.
>> I've got the OS to recognize both new tape drives but I can't get the 
>> system to recognize the robotic arm.
>> From the output of the sgscan I see only the ADIC connected.
>> I ran the procedure to add a new robot from the doc.
>>  
>>
>> /usr/sbin/modinfo | grep sg
>>
>> /usr/sbin/rem_drv sg
>>
>> /usr/bin/rm -f /kernel/drv/sg.conf
>>
>> /usr/openv/volmgr/bin/driver/sg.install
>>
>> cd /usr/openv/volmgr/bin/driver
>>
>> /usr/openv/volmgr/bin/sg.build all -mt 15 -ml 1
>>
>> and added/replaced content on
>>
>>
>> /kernel/drv/st.conf
>>
>> reboot -- -r
>>
>> We connected the robot to windows 2k3 server and it works fine under 
>> BackupExec, but I can't get it working under Solaris 8.
>>
>> Any help will be very welcome!
>>
>> Thanks!
>>
>>  
>>
>> Francisco
>
> _______________________________________________
> Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
>