Hi ,

You need to check your devlink.tab and make sure it is in your sg.links
file when you create your sg devices.

On Wed, 5 May 2004, Hardt, Jon wrote:

> Hmmm... I wonder if you might be right. I doubt its a coincidnce that the
> only LUNS that work are LUN 0 on their respective targets. When I edited my
> st.conf file, I used 5 LUNs (zero through four) for each target; I'm
> wondering if maybe I should only use one LUN (LUN 0) for each target
> (basically the st.conf default with the wide SCSI targets uncommented).
>
> -----Original Message-----
> From: Mike Ekholm [mailto:ekholm AT ekholm DOT org]
> Sent: Wednesday, May 05, 2004 2:00 AM
> To: Craig Richmond
> Cc: Mike Ekholm; Veritas-Bu (E-mail)
> Subject: Re: [Veritas-bu] Eight new SDLT320 drives not being recognzied
> by NBU Datacenter 3 .4
>
>
> On Wed, May 05, 2004 at 08:16:46AM +0100, Craig Richmond wrote:
> > At 1:44 -0500 5/5/04, Mike Ekholm wrote:
> > >The no device or address tells me that tar is not going to do crap,
> sgscan
> > >looking down the path can see the drives fine, but at this point solaris
> > >can not see anything.
> > >
> > >I have never used a tape device that was not configured as lun 0, is
> > >this supported on solaris?
> >
> > /kernerl/drv/st.conf
> >
> > Just like sd.conf
> >
> > name="st" class="scsi"
> >         target=0 lun=0;
> >
> > name="st" class="scsi"
> >         target=1 lun=0;
> >
> > name="st" class="scsi"
> >         target=2 lun=0;
> >
> > name="st" class="scsi"
> >         target=3 lun=0;
> >
>
> Yeah, that is what I am use to seeing, every tape device as a lun 0 :-)
>
>
> -Mike Ekholm
> --
> Mike Ekholm, UNIX Sys Admin  -  ekholm AT ekholm DOT org
> web: http://www.ekholm.org ham: kc0mpu irc: Nalez
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> UNIX - The Swiss army knife of software.
>
> _______________________________________________
> Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
>