One of your tape drive not configured correctly. Use the command
%install%/volmgr/bin/tpautoconf -show to re-map the tape drives. Or use
../tpautoconf -t
Tommy

-----Original Message-----
From: veritas-bu-admin AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-admin AT mailman.eng.auburn DOT edu] On Behalf Of Anderson H
Leandrine
Sent: Wednesday, March 10, 2004 2:03 PM
To: bu
Cc: rodrigo.otavio AT cimcorp.com DOT br; cduarte AT cimcorp.com DOT br
Subject: [Veritas-bu] L100 with two bridges FC-420 (ATTO)
Importance: High


Hello Veritas Specialists

        Currently, I'm having a problem with a library - a four SDLT
drive L100 and two bridge FC-420, those bridges are connected to two
Brocade switches. I'm using NetBackup 3.4.1 (patch 6) software at SAN.

        When I run the robtest command, I get the following output:

Opening \\.\Scsi6:
Enter tld commands (? returns help information)
s d
drive 1 (addr 128) access = 1 Contains Cartridge = yes
Source address = 200 (slot 9)
Barcode = 000804S
SCSI ID from drive 1 is 1
drive 2 (addr 129) access = 1 Contains Cartridge = yes
Source address = 199 (slot 8)
Barcode = 000802S
SCSI ID from drive 2 is 2
drive 3 (addr 130) access = 1 Contains Cartridge = yes
Source address = 219 (slot 28)
Barcode = 000828S
SCSI ID from drive 3 is 4
drive 4 (addr 131) access = 0 Contains Cartridge = no
Sense code = 0x83, Code qualifier = 0x4
drive 5 (addr 132) access = 1 Contains Cartridge = yes
Source address = 241 (slot 50)
Barcode = 000810S
SCSI ID from drive 5 is 6
READ_ELEMENT_STATUS complete

The problem is the fourth drive (number 4), because the SCSI message
appear: Sense code = 0x83, Code qualifier = 0x4.

So, I have FOUR drives, but the robtest command reads FIVE drives,
returning the SCSI error for drive 4.

Does anybody know what could be happenning?

Thanks,

Anderson Leandrine
www.CIMCORP.com.br


_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu