We added a new Quantum Superdlt 220 tape drive to our L180 attached by SCSI 
cables to a STK 3250 router and than fiber cable to the SUNfire 280R through an 
Emulux FC card.  We have 3 tape drives already that work fine but the new one 
isn't seen by the OS for some reason.  All four tape drives are listed in the 
probe-scsi-all and in the configuration on the router lun 0 with 4 tape drive 
targets are there.  I've talked to StorageTek, Veritas, and SUN but have not 
found a solution.  The tape drive was swapped with another and it works.  
StorageTek says if the router shows everything fine than the cables are OK.

Any ideas of what is preventing the OS from building the /dev/rmt with the boot 
-r and also tried the devfsadm -C.

Cheryl King
System Administrator II

Intrado Inc.
1601 Dry Creek Drive
Longmont, CO 80503
direct: 720.864.5162
mobile: 720.840.4786
page:  303-207-4648
fax: 720.494.6600
email: cheryl.king AT intrado DOT com

Intrado.® Informed Response. ®
www.intrado.com 

ATTENTION:

The information contained in this electronic message and any attachments to 
this message are intended for the exclusive use of the addressee(s) and may 
contain confidential or privileged information. If you are not the intended 
recipient, please notify Intrado Inc. immediately at 720.494.5800 and destroy 
all copies of this message and any attachments.