[Veritas-bu] Netbackup Data Center 4.5 How to use more than one drive
2003-11-07 00:46:23
Hi all,
I have been put in charge of a Netbackup Domain. Since all my experience is
with Omniback, needless to say I am in need of some info. I have read the
admin guides, etc, but can't seem to solve this problem:
I have configure the robot and the two drives on the library, I have created a
storage unit for this library, set the Multiplex Per drive to 4 and have set
the max concurrent drives used for backup to 2. I have created three volume
pools one for the Windows backups and one for the Unix backups and of course a
scratch pool. I have added 14 tapes to the library, and have done the robtest
etc, and also made sure that the tapes show up in the scratch volume pool.
I have the Windows policy set to start at 9pm and the Unix policy to start at
10pm. The Windows policy takes 2 hours to complete it is still active when
the Unix one kicks off. However, why won't the Unix policy use the other
drive? I look at the Activity monitor and can see that the Windows backup job
is writing to the tape, but the Unix job is queued until the Windows backup is
complete.
I have the max multiplex set to 4 on both policies and both have multiple data
streams enabled, both point to the same STU and their respective volume pool.
Can anyone tell me what I am doing wrong? Do you have to create an (2) STUs?
Even though I am only using a single library?
This is driving me crazy, I've done everything I could.
Thanks for your help.
-Adam
----------------------------------------------------------------------
This mail sent through Toaster-Horde (http://qmailtoaster.clikka.com/)
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Veritas-bu] Netbackup Data Center 4.5 How to use more than one drive,
adam AT tsatech DOT com <=
|
|
|