Below is what I use as a guide for our P3000 robtest commands.
 
 
 
To exit the utility, type q or Q.
init                      - Initialize element status
rezero                    - Rezero unit
mode                      - Mode sense
inport                    - Ready inport
extend                    - Extend E/E port
retract                   - Retract E/E port
m <from> <to>             - Move Medium
pos <to>                  - Position to drive or slot
s <type> [num]            - Read element status
inquiry                   - Display Vendor and Product ID
   <from> <to> specifies drive (d#), slot (s#), transport (t)
           or inport/outport (i)
   <d#|s#|i#|t#> is drive #, slot #, inport/outport # or transport #
           [#] is number of elements for s, d, i, or t
    NOTE - slot # is 1 - Number Slots
           drive # is 1 - Number Drives
           inport/outport # is 1 - Number Mailslots
           transport # is 1 - Number Transports
   <type> = (d)rive, (s)lot (i)nport/outport or (t)ransport
   [num] - slot number to status only one slot
unload <drive>           - Issue SCSI unload
   <drive> = d1 or 1, d2 or 2, d3 or 3 ... d80 or 80
 
-----Original Message----- 
From: Paul Flood [mailto:flood AT nortelnetworks DOT com] 
Sent: Thu 11/21/2002 6:52 AM 
To: Veritas-bu AT mailman.eng.auburn DOT edu 
Cc: 
Subject: [Veritas-bu] P3000 Library robtest commands and options



        Hi,
        
        Can you point to me to any documentation referencing commands and
        options for 'robtest'
        
        Any help would be appreciated.
        
        Thanks.
        
        Paul Flood
        Computer Sciences Corporation
        
        _______________________________________________
        Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
        http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu