EMC makes software called PowerPath that does just this.
You can also make use of dmp if you are using Veritas' Volume manager (but
it needs a patch you must request from Veritas support to work properly).

-----Original Message-----
From: Diaz, Gustavo [mailto:gdiaz AT hprmail DOT com]
Sent: Tuesday, August 27, 2002 9:19 AM
To: Veritas-bu (veritas-bu AT mailman.eng.auburn DOT edu)
Subject: [Veritas-bu] Failover for Fibre channel cards


Hello all,
          Is there any software which would provide dual paths for failover
on fibre channel cards? We have Sun 220 servers with qlogic cards going to a
brocade switch going to an EMC 4700fc.

Thanks,
Gus Diaz

_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu