Hi,
Just wanted some advice if possible about streams in Netbackup 3.4 and how
tapes are assigned to jobs!
Last night I created a new Backup Policy which contains 14 Streams.
Originally this Job only contained one stream and all Data was backed up to
a single tape.

Now, because I have created streams, 2 tapes were used. To make matters
worse, the 2nd tape only contains approx 65MB of Data on a 200GB compressed
Tape!

Is there a way I could have told this job to use one tape for this entire
job? Because we are tight on using tapes, I feel this is wasting a good
valuable tape.

Any ideas on how to get around this?

Thanks

Simon Weaver
NT Domain Administrator
Ext. 5544
Tel: 02392-705544 (Direct Dial)
Simon.Weaver AT Astrium-Space DOT com

...
This email is for the intended addressee only.
If you have received it in error then you must not use, retain, disseminate
or otherwise deal with it.  Please notify the sender by return email.
The views of the author may not necessarily constitute the views of Astrium 
Limited.
Nothing in this email shall bind Astrium Limited in any contract or obligation.

Astrium Limited, Registered in England and Wales No. 2449259
Registered Office: Gunnels Wood Road, Stevenage, Hertfordshire, SG1 2AS, England