Hi,
you can use:

echo s i | tldtest -p X -b X -t X -l X

where p is port, b is bus, t is target and l is lun (scsi address)

Sincerely Yours

DATASEC

Javier González
CEO / GM IT Services

Giessenweg  21
CH-6403  Küssnacht am Rigi
Switzerland
Tel:         +41 41 852 1066
Fax:         +41 41 852 1065
Mobile:      +41 76 384 2002


jg AT datasec DOT ch
www.datasec.ch



-----Original Message-----
From: veritas-bu-admin AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-admin AT mailman.eng.auburn DOT edu]On Behalf Of Casey
Feskens
Sent: Mittwoch, 24. Juli 2002 17:02
To: Cosmin.Oprea
Cc: 'veritas-bu AT mailman.eng.auburn DOT edu'
Subject: Re: [Veritas-bu] read the tapes from the mailslot


On Wed, 3 Jul 2002, Cosmin.Oprea wrote:

> How do you read the label of the tapes in the mailslot (StorEdge Tek L180
> for instance)
>
>From my experience, Veritas in and of itself doesn't really get to play
with the mailslot other than being able to empty or fill it.

What I do is plug

AUTO_UPDATE_ROBOT

into my vm.conf file.  Whenever I plug a tape into the mailslot, the slot
gets emptied and NetBackup catalogs the media if it hasn't been before.
Then your media will show up in the library reports.

If you're really motivated, you could use robtest to view the status
of the mailslot.

Take care,

---------------------------------------------
Casey Feskens <cfeskens AT willamette DOT edu>
System Administrator/Network Svcs. Consultant
Willamette University, Salem, OR
---------------------------------------------


_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu