Try a boot -r.  The /reconfigure method isn't always reliable.
If you still have a problem run a probe-scsi-all from the ok prompt -- if
you can't see your drives at that level then you know you have a
connectivity problem.
-Dave

-----Original Message-----
From: Robert L. Harris [mailto:Robert.L.Harris AT rdlg DOT net]
Sent: Thursday, February 07, 2002 9:51 AM
To: Veritas-BU
Subject: [Veritas-bu] JNI and drives



I'm rebuilding a server.  It has 2 JNI cards and is attached to a Gator
with 20 drives.  I have 12 of the drived partitioned off to this server
in the Gator config.

Downloaded the latest JNI drivers and ezfibre, installe both.  EZFibre
is slow as all get out (Java GUI) but still doesn't seem to find the
drives.  Rebooted with a /reconfigure (same as boot -r).  There are no
entries created in /dev/rmt meaning it's not seeing the drives.  Has
anyone run into anything like this?



:wq!
---------------------------------------------------------------------------
Robert L. Harris                |  Micros~1 :  
Senior System Engineer          |    For when quality, reliability 
  at RnD Consulting             |      and security just aren't
                                \_       that important!
DISCLAIMER:
      These are MY OPINIONS ALONE.  I speak for no-one else.
FYI:
 perl -e 'print $i=pack(c5,(41*2),sqrt(7056),(unpack(c,H)-2),oct(115),10);'

_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu