Hi,
Does anyone use LTO (seagate) with SGI? What about over fibre with
STK/Crossroads briges, qlogic card?
I am having some problems ;)
1st only one drive per bridge shows up, if there is more than one, the
scsi/hwpath is created but the corresponding /dev/rmt/tpsXXYYZZ is not... Does
not show up on hinv -vmm either.. (sounds like a MAKEDEV bug).
2nd I can do a mt -f /dev/rmt/tps** status, but unload etc. times out: As well
as the Sense information... I note the ql (qlogic probibly) rather than the tps
in there too... Needless to say my robotics work mighty fine.
Jan 24 10:00:36 6A:pie unix: ql15d1l0: command timeout: 0x12, notified demon t
o abort iocb, port id 0xe8
Jan 24 10:00:36 6A:pie unix: ql15d1l0: command timeout: abort of iocb complete
, port id 0xe8
Jan 24 10:02:21 6A:pie unix: ql15d1l0: command timeout: 0x12, notified demon t
o abort iocb, port id 0xe8
Jan 24 10:02:21 6A:pie unix: ql15d1l0: command timeout: abort of iocb complete
, port id 0xe8
Any one running into the same problems? Also which special file do you all use
for LTO/netbackup? /rmt/tps*****nrvc,? nrcsc etc??
Any help would be appriciated.
Regards,
Yucel
---------------------------------------------------------
Yucel M. Erbilgic
erbilgic.ym AT pg DOT com
(513) 945-1859
|