You did it right all along, up until the point you upgraded to 3.4. In 3.4
Veritas starts requiring the passthrough drivers.

Jeff Boleman
Systems Administrator III
Andersen Corporation
jboleman AT andersencorp DOT com


-----Original Message-----
From: bryan_bahnmiller AT agilent DOT com [mailto:bryan_bahnmiller AT agilent 
DOT com]
Sent: Friday, March 30, 2001 4:09 PM
To: veritas-bu AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] Which HP/UX driver for robots


All,

  We have been having some issues with downed drives. We are running an
N4000 with HP/UX 11.0 and NetBackup 3.4.1 (3.4 with J0850645 patch.) We are
running over LVD SCSI to a Scalar 1000 with IBM LTO drives. 

  Tech support claims we should be using the "spt" or "sctl" drivers to talk
to the library. We have always used the "schgr" driver in the past, which
creates the /dev/rac/cXtXdX device. Have we been doing this wrong all this
time?

  Any opinions would be welcome!


          Bryan


Bryan Bahnmiller
Agilent Technologies
(719) 590-3262 
_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu