Ty:
Where is the robotic control for the P3000?
I have seen drives go down when there was a problem
with the communication to the robotic control (either
not configured properly, or an RS232/SCSI problem).
other than that, as others have suggested, check the
syslog for ltid errors.
David Chapa
Quoting Ty Young <tyyyoung2 AT home DOT com>:
> With the help of readers on this mailing list, I've
been able to do quite a
> bit to get my HP box up and talking not only to its
attached ATL P3000
> library but also to NetBackup 3.4 (Data Center.)
However...
>
> I'm running into a problem where the drives seem
to 'down themselves' after
> a period of time. Not sure why. From an OS
standpoint, the eight drives
> and the robot all exist and are fine (indeed, I was
able to create .tar
> files on each drive successfully, as well as
using 'mc -p' commands to move
> tapes around within the jukebox.)
>
> Has anyone else run into this behavior?
>
> Thanks,
>
> -ty
>
> _______________________________________________
> Veritas-bu maillist - Veritas-
bu AT mailman.eng.auburn DOT edu
>
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-
bu
>
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
David A. Chapa 847 413 1144 p
Director of Technology 847 413 1168 f
DataStaff, Inc. http://www.datastaff.com
nbu-lserv AT datastaff DOT com majordomo AT datastaff DOT com
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
|