Can you post the enteries of your st.conf;
Ayaz
> -----Original Message-----
> From: veritas-bu-admin AT Eng.Auburn DOT EDU
> [mailto:veritas-bu-admin AT Eng.Auburn DOT EDU]On Behalf Of Mike Andres
> Sent: Wednesday, November 15, 2000 4:59 PM
> To: 'Veritas NBU'
> Subject: [Veritas-bu] tape and sgscan oddity
>
>
> Hi,
>
> We have a Sun E450 running Solaris 2.6 that is fibre connected to some
> Brocade switches and bridged to DLT7000's. We cleared out the dev/rmt
> directory as well as the dev/sg directory, then did a reconfigure boot.
> During boot, all DLT's are found and configured and dev/rmt as well as
> dev/sg are pupoulated with the appropriate files. However, when we try to
> do an mt status on each drive, we get "no such device or address" error.
> Also, when we run sgscan, all tapes and the changer are reported but they
> are all reported on the same controller number even though 5 of the tapes
> are on one fibre controller, 5 on another and the robot is on a SCSI
> controller. I don't think this is an issue specific to NBU, but
> I'm hoping
> (for my sake, not yours ;-) ) that somebody may have run into something
> similar to this.
>
> Thanks for any help,
> -mike andres
>
>
> _______________________________________________
> Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
>
|