[Veritas-bu] RE: Veritas-bu digest, Vol 1 #33 - 18 msgs
2000-05-09 05:03:31
Paul,
my answer at your questions are:
1/ You can wrote on DLT IV on DLT 4000 and read the DLT IV on DLT 7000 , it
seems to look good.
2/ After your upgrade you can use the same DLT IV on the DLT 7000.
3/ An exemple of your st.conf definition:
Q-DLT7000 = 1,0x36,0,0x29639,4,0x84,0x83,0x0,0x85,3;
Pierre VIDAL
European SAN Lab Engineer
E.Mail: Pierre_Vidal AT StorageTek DOT com
StorageTek
INFORMATION made POWERFUL
----------------------------------------------------------------------------
--
Date: Wed, 03 May 2000 08:48:10 -0500
From: Paul Windsor <windsorpj AT lmtas.lmco DOT com>
To: veritas-bu AT mailman.eng.auburn DOT edu
Organization: Computer Sciences Corp.
Subject: [Veritas-bu] DLT 4000 to DLT 7000 conversion
We are using NetBackup 3.2 on a SUN4000 (Solaris 2.6) and using two STK
9710 silos with 10 DLT 4000 each. Our plan is to upgrade the tape drives
to DLT 7000s. The questions are:
1. Will NetBackup be able to read existing backup tapes ( the DLT IV
carts are used )
2. After the upgrade will the tapes be written in DLT7000 mode or
must the tapes be blank labeled
3. I have seen several different DLT7000 definitions for the st.conf
file .... what is correct
Thanks for the help,
Paul
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
- [Veritas-bu] RE: Veritas-bu digest, Vol 1 #33 - 18 msgs,
Vidal , Pierre S VidalPS <=
|
|
|