Hi Tim,
I was looking on the internet, I thought the feature is NSR_READ_SIZE
described in (
http://nsrd.moab.be/2012/07/07/networker-7-6-sp4-is-generally-available/#1).
On a side note? Would NSR_DEV_BLOCK_SIZE work if I was writing to
DataDomain? I have some large databases that I am backing up that might
improve with a larger BLOCK_SIZE.
On Thu, Nov 15, 2012 at 6:49 AM, Lemons, Terry <terry.lemons AT emc DOT com>
wrote:
> Hi Joe
>
> This can be set in several ways. One is to set an environment variable
> with the needed value. Open the 'NetWorker Administration Guide', and
> search for 'NSR_DEV_BLOCK_SIZE'; that will get you to the section that
> talks about this. The other way is to use the NetWorker administration
> program (either the 'nsradmin' CLI or the NMC GUI) to set the value of the
> resource that controls this. This didn't work in even fairly recent
> versions of NetWorker, but I believe it works in the latest (search the
> archive of this mailing list, or the other NetWorker resources on the EMC
> support site, for the details).
>
> Hope this helps.
> tl
>
> -----Original Message-----
> From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU]
> On
> Behalf Of joe lin
> Sent: Thursday, November 15, 2012 2:23 AM
> To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
> Subject: [Networker] NSR76 SP4 & Optimized disk reading ...
>
> Hi Tim,
>
> How do you manually set the block size tuning in 7.6.4/8.0?
>
>
|