Re: [Networker] Question on tape rewinding???
2010-03-25 17:18:09
Terveen, Frank wrote:
Is this on Windows ?
This is on Unix (Linux).
met vriendelijke groeten / With kind regards
Frank Terveen
--------------------------
Sent via BB
----- Oorspronkelijk bericht -----
Van: EMC NetWorker discussion <NETWORKER AT LISTSERV.TEMPLE DOT EDU>
Aan: NETWORKER AT LISTSERV.TEMPLE DOT EDU <NETWORKER AT LISTSERV.TEMPLE DOT EDU>
Verzonden: Thu Mar 25 18:33:41 2010
Onderwerp: [Networker] Question on tape rewinding???
Kind of a dumb question here ...
1. I notice that when I go to clone a save set that the source tape will
forward a certain number of files (e.g. 173) and then read, with the
target tape moving forward and then writing - all well and fine.
2. But if I then clone another save set on the same source tape, and
this is just a few file beyond the previous one (e.g. 177), it again
forwards that number of files (in this case 177). It appears that after
each clone, the source tape rewinds??
Is this correct behavior on non-rewind devices? Perhaps, the non-rewind
only applies when writing data and not reading data?
3. I then run another clone wherein I give it a list of all the ssids on
the source tape, and it simply reads solid all the way through and does
not mention anything about forwarding or rewinding. It just reads
uninterrupted. Does this make sense?
George
--
George Sinclair
Voice: (301) 713-3284 x210
- The preceding message is personal and does not reflect any official or
unofficial position of the United States Department of Commerce -
- Any opinions expressed in this message are NOT those of the US Govt. -
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|