[Networker] Port numbers for NMC?

A few questions on port numbers for NMC?

The installation documentation says:

"For the web server port number, use the default port number (9000) oruse a custom port number. Valid port numbers are between 1024 and 49151.

For the Console server, use the default port number (9001) or use acustom port number. Valid port numbers are between 1024 and 49151.Note: Do not use port numbers already in use. Port 2638 is reserved bythe NetWorker Console software by using the Tabular Data Stream (TDS)protocol to communicate with the database. Port 9002 is the preferredport for EMC Backup Advisor product."

1. I thought I remember reading somewhere - maybe on this listing -about some command to set ports that you're supposed to run beforeinstalling NW on the server? Maybe that was something else entirely?


2. Do most folks use the defaults?

3. I assume the installation will prompt for these?

4. Best way to change these values later?

Thanks.

--
George Sinclair
Voice: (301) 713-3284 x210

- The preceding message is personal and does not reflect any official orunofficial position of the United States Department of Commerce -

- Any opinions expressed in this message are NOT those of the US Govt. -

To sign off this list, send email to listserv AT listserv.temple DOT edu and type 
"signoff networker" in the body of the email. Please write to networker-request 
AT listserv.temple DOT edu if you have any problems with this list. You can access the 
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER