Re: [Networker] LTO tape levels
2009-06-03 11:28:41
On 6/3/09 11:04 AM, Nico De Ranter wrote:
I always assumed the barcode labels on LTO tapes could contain any
sequence of letters and digits. However I recently upgraded our LTO-1
setup to LTO-4. When I replaced catridges today I ran out of LTO-4
labels (that came with the new device) so I took one of the old labels
(ending in -L1) and put that on the LTO-4 tape. Now Networker is
refusing to label the tape claiming it's an "incompatible medium".
I believe it is using the label to say this is an LTO1 tape -- LTO4 drives can not read or
write LTO1 media. The LTO spec says read two generations old, read/write previous and current
generation -- so, I hope you have held onto a couple of LTO1 drives to read your existing media.
--
Frank Swasey | http://www.uvm.edu/~fcs
Sr Systems Administrator | Always remember: You are UNIQUE,
University of Vermont | just like everyone else.
"I am not young enough to know everything." - Oscar Wilde (1854-1900)
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|