Re: [Networker] Scanning command
2009-05-19 10:40:17
If you want to scan in a specific save set, and the tape is in
/dev/nst0:
scanner -ivv -S <saveset id> /dev/nst0
-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On
Behalf Of surya
Sent: Tuesday, May 19, 2009 8:58 AM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] Scanning command
Hi all,
what will be the command to scan a tape fully... after loading the tape
to device will the following command be able to scan the tape.. ?
# scanner devicename
please let me know..
tHNAKS IN ADVANCE
REGARDS,
Surya...
+----------------------------------------------------------------------
|This was sent by suresh0886 AT yahoo.co DOT in via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|