[Networker] Staging a portion of a saveset
2009-05-11 10:56:00
I am dealing with the aftermath of a hardware issue that left me with several clone tapes that
were severely underutilized (less than 50 GB used on an LTO-4 cartridge). Sadly, in trying to
stage these small fragments to better utilize the media, I am discovering (yet again) that I am
also staging large portions of other tapes that were fully utilized and now they are going to
be underutilized. I'm almost to the point of scrapping the entire clone run from last week and
start over (which of course, I don't have the time to do).
Wouldn't it be really nice if NetWorker provided the capability to stage just the portion of
the SSID/CLONEID pair that was on a particular tape volume to a new tape? I think it would be.
Does anyone else agree?
--
Frank Swasey | http://www.uvm.edu/~fcs
Sr Systems Administrator | Always remember: You are UNIQUE,
University of Vermont | just like everyone else.
"I am not young enough to know everything." - Oscar Wilde (1854-1900)
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Networker] Staging a portion of a saveset,
Francis Swasey <=
|
|
|