Re: [Networker] Compress Savesets
2008-12-05 18:57:05
If you are fitting 700GB on a LTO3 tape, then the tape drive hardware is
compressing it. If you turn on client side compression you will backup
roughly the same amount of original data, and the used will show 400GB
when its full.
-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On
Behalf Of psoni
Sent: Saturday, 6 December 2008 7:25 AM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] Compress Savesets
What I meant was if there are any other way to enable compression on
individual volume except applying directive to the client resource ?
I am using LTO-3 400GB/800GB cartridges and most of the tapes are
currently showing close to 700 GB under "used" tab in NMC
I haven't applied compression directive to any of the clients yet.
Is there any other way to verify this ?
NOTICE
This e-mail and any attachments are confidential and may contain copyright
material of Macquarie Group Limited or third parties. If you are not the
intended recipient of this email you should not read, print, re-transmit, store
or act in reliance on this e-mail or any attachments, and should destroy all
copies of them. Macquarie Group Limited does not guarantee the integrity of any
emails or any attached files. The views or opinions expressed are the author's
own and may not reflect the views or opinions of Macquarie Group Limited.
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|