[Networker] Restarting a failed group....
2008-09-11 08:06:46
In prior versions of networker (7.2.2), when a group had failures,
re-starting the group only ran the failed save-sets and not the
successful ones. Now when I restart a failed group, it attempts to run
ALL save-sets in the group. Seems the 'restart' functionality is broken
with this new release. If I only want to run the failed save-sets, I
have to create a temporary group and assign just the clients/save-sets
that failed from the other group to it... And then start the new
group... All to get back to the prior functionality that existed
before... This is not good.
Has anyone else experienced this with 7.4.1 sp2 ?? If so, did support
have a solution for it ?
Regards,
Paul
--
/"\
\ / ASCII RIBBON CAMPAIGN
X AGAINST HTML MAIL
/ \
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Networker] Restarting a failed group....,
Goslin, Paul <=
|
|
|