[Networker] Query in Staging from adv_file
2008-08-18 04:58:34
I have few adv_file device and I have created a staging policy and add all the
adv_file to the same pool because, all the adv_file devices has the same
destination pool. But when I am giving "stage all save sets" from the staging
policy properties. NetWorker is staging from one adv_file to one physical
drive. I have enabled parallelism on physical drive level set to 4. But
networker is not doing multiplexing for staged data. The physical drive is
under utilized. If I do parallelism, I think I can make the drive to perform at
its maximum.
Is it Networker's behavior of not to multiplex data staged from disk to tape.
So will networker will use one dedicated drive per stage session from a
adv_file.
Plz advice.
+----------------------------------------------------------------------
|This was sent by anandhg AT gmail DOT com via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Networker] Query in Staging from adv_file,
anandhg <=
|
|
|