EMC NetWorker discussion <NETWORKER AT LISTSERV.TEMPLE DOT EDU> wrote on
08/11/2008 01:02:28 PM:
> I'm wondering .. if I have a SDLT-320 tape, can I load it into a
SDLT-600
> library, and run say "scanner -m" or "scanner -i" on it? It shiould
work,
> I think , since I am not writing to the tape.
Apparently not .. it complained that that it knew the tape was an
SDLT-320, and it was in an SDLT-600 drive, and so wouldn't "scanner -i"
(because it already existed in the media database).
<SIGH>
Suggestions?
> This would make my restores
> go faster, since I could be running multiple scanner commands at once,
> then. (I've found out you don't really need to run them sequentially; as
> long as you "scanner -m or -i" on the entire set, you can do them
> simultaneuosly, and ignore the "Load tape 1234" message, if you've
already
> scannered tape 1234, or are scanning tape 1234)
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|