Re: [Networker] Networker Can not unload tapem backup keeps waiting
2008-05-10 23:37:18
Hi Frank,
Thanx for your help. Yes value was set to 0. I have changed it to 10 now.
Best Regards,
Shahid Qavi
Frank Swasey wrote:
Hi,
I will assume that the "idle device timeout" value is at the default
of 0. You can check that by setting diagnostic mode in the view menu
of NMC, then open the properties of the jukebox, and select the Timers
tab.
A value of 0 means that networker should never unload an idle device
and it will quite stubbornly leave tapes in drives forever demanding
that writable tapes be mounted.
I have developed a habit of always updating that value to 10 (minutes).
Frank
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with
this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|