That is more than sufficient
As long as you're not going to try coexisting 7.2 Jumbo and 7.3.x I
wouldn't worry about it
regards
Jerry
-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On
Behalf Of George Sinclair
Sent: Monday, September 10, 2007 2:07 PM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] Recommendations on 7.2.2 jumbo for 7.x.x security
fix?
Hi,
I need to install 7.x.x security fix (nsrexecd binary replacement) for a
Solaris 9 primary server and two Linux storage nodes. Server is running
7.2.2 64-bit (non-jumbo). Both snodes are running 7.2.2 32-bit
(non-jumbo). Any suggestions or pit falls to watch out for? Not ready
yet to go for 7.3.x just yet, but they will drop support for 7.2.2
within 6 months, I know.
Here's the steps I was going to do:
1. Create level full backup of server (and all client indexes just in
case).
2. Stop software on server and snodes.
3. Uninstall 7.2.2 software on primary server, and then (a) install
7.2.2 jumbo (64-bit) version and then (b) copy new nsrexecd binary into
place.
4. Ditto for snodes (but with 32-bit version).
5. Start up software on primary server, followed by snodes.
6. Upgrade all clients to 7.2.2 jumbo with similar nsrexecd replacement.
Clients might take another day, but a 7.2.2 client should be able to
work with the 7.2.2 jumbo server OK ... I would think?
Will it be necessary to re-configure the snodes and/or jukebox
configurations? Seems to me that I had to do that once before when I
upgraded the server software but can't recall if that was to a new
release or not. I would think that the configuration would remain
untouched and everything should come up and work same as before with no
re-inventory of tapes needed, etc., but ...
Thanks.
George
--
George Sinclair - NOAA/NESDIS/National Oceanographic Data Center
SSMC3 4th Floor Rm 4145 | Voice: (301) 713-3284 x210
1315 East West Highway | Fax: (301) 713-3301
Silver Spring, MD 20910-3282 | Web Site: http://www.nodc.noaa.gov/
- Any opinions expressed in this message are NOT those of the US Govt. -
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
