Hi Elvis
It sounds like your are doing your primary backups to disk, and later want to
move the savesets to tape. That is exactly the use case that NetWorker's
staging functionality was created for. Read up on staging in the NetWorker
Administrator's Guide.
tl
Terry Lemons
Backup Platforms Group
EMC²
where information lives
4400 Computer Drive, MS D239
Westboro MA 01580
Phone: 508 898 7312
Email: Lemons_Terry AT emc DOT com
-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On
Behalf Of Elvis Ademba
Sent: Thursday, July 26, 2007 12:59 PM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] Cloning
I would like to get the commands or advice on how to tell networker to clone
data to tapes so that when it comes to backup time, there is enough disk /
storage space ... sometimes i get errors where the space ran out and
networker had to clone data just to free up space before continuing with the
backup.
but often during the day when my backups are not running, networker clones
some data to tape but not as much as i would like it to. i often encouter
this error on weeknd when its a difficult time and no staff in office.
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|