Networker

Re: [Networker] Setting up a tape library on RH Linux via fibre

2007-07-23 08:32:41
Subject: Re: [Networker] Setting up a tape library on RH Linux via fibre
From: Francis Swasey <Frank.Swasey AT UVM DOT EDU>
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Date: Mon, 23 Jul 2007 08:29:21 -0400
On 7/23/07 8:21 AM, Stan Horwitz wrote:


Thanks so much for your help. I am wondering something though. The inquire command says each of the five scsi devices is a robotic controller and sjisn reports the same information for each devices. Somehow, I suspect something is wrong.

Stan,
At the end of June, I installed a new Qualstar 832700 (XLS) tape library. And inquire on Solaris 9 (NetWorker 7.3.2JumboUpdate1 build 399) did the same thing to me on that device. Except it went really crazy and found over 65 addresses for the robotics. We just picked the lowest numbered one and did the jbconfig with it. I haven't taken the time to open an issue with NetWorker.

--
Frank Swasey                    | http://www.uvm.edu/~fcs
Sr Systems Administrator        | Always remember: You are UNIQUE,
University of Vermont           |    just like everyone else.
  "I am not young enough to know everything." - Oscar Wilde (1854-1900)

To sign off this list, send email to listserv AT listserv.temple DOT edu and type 
"signoff networker" in the body of the email. Please write to networker-request 
AT listserv.temple DOT edu if you have any problems with this list. You can access the 
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER

<Prev in Thread] Current Thread [Next in Thread>