Re: [Networker] Faulty device status info
2006-11-27 09:37:32
Stan,
Have you tried editing the jukebox, volumes tab and removing the
offending entry from loaded volumes, loaded barcodes and loaded slots?
Regards
Bob
>-----Original Message-----
>From: EMC NetWorker discussion
>[mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On Behalf Of Stan Horwitz
>Sent: 27 November 2006 14:18
>To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
>Subject: [Networker] Faulty device status info
>
>I had an backup fail on me over the holiday weekend. This is
>on a Sony PetaSite connected via fibre to a Sun Solaris 9
>server. I think the tape cartridge was faulty. The problem is,
>I can't seem to convince NetWorker 7.2.1 to that this
>particular tape cartridge is no longer receiving data. I used
>my tape library's GUI to remove that tape, but NetWorker
>insists its still being written to, even though the NetWorker
>GUI and "nsrjb -C" both indicate the tape drive in question is
>not loaded with anything.
>
>Does anyone have any tricks that would allow me to change the
>status of this device so that I can use it again without
>shutting down the NetWorker software or doing a reboot? I
>tried killing off the relevant nsrmmd process, so perhaps
>that's what is causing this problem.
>
>To sign off this list, send email to
>listserv AT listserv.temple DOT edu and type "signoff networker" in
>the body of the email. Please write to
>networker-request AT listserv.temple DOT edu if you have any problems
>with this list. You can access the archives at
>http://listserv.temple.edu/archives/networker.html or via RSS
>at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
>
>
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|