> scanner -S 4045853953 /dev/rmt/c4t5d0BESTnb | uasm -rv
> 
> The SaveSet spans across multiple tapes and the problem is that although we
> have an autochanger setup (which works fine during backup) we have to
> manually load each tape into the drive with this particular scanner
> command. Could anybody advice if we are missing something or if there is a
> way to automate it.

You could use 'nsrjb' to put a tape in the drive you want, then fire
scanner on the drive.  Scripting that would be somewhat annoying if you
wanted to handle different error conditions, but it's basically a simple
loop if you ignore them.

Would it be possible to just do a saveset recovery directly (which would
load the tapes), or is this some sort of cross-platform recovery that
you're doing?

-- 
Darren Dunham                                           ddunham AT taos DOT com
Senior Technical Consultant         TAOS            http://www.taos.com/
Got some Dr Pepper?                           San Francisco, CA bay area
         < This line left intentionally blank to confuse you. >

To sign off this list, send email to listserv AT listserv.temple DOT edu and 
type "signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu 
if you have any problems
wit this list. You can access the archives at 
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER