Ty,
to setup FC devices you do a
# cfgadm -al
(lists the FC cards and the connected devices). Entries which are
"unconfigured" can be configured by
# cfgadm -c configure c5::5006xxxxxxxxxxxx
(configure a specific WWN)
or
# cfgadm -c configure c5
(configure all WWNs connected to controller 5)
If you would like the connected WWNS to specific "/dev/rmt/Xxx"
devices, you can modify the file "/etc/devlinks.tab" and add entries as
follows :
#
# Begin TAPE section
#
type=ddi_byte:tape;addr=w5006xxxxxxxxxxx1,0; rmt/250\M0
type=ddi_byte:tape;addr=w5006xxxxxxxxxxx2,0; rmt/251\M0
type=ddi_byte:tape;addr=w5006xxxxxxxxxxx3,0; rmt/252\M0
#
# End TAPE section
#
After modifying the file, do a "rm /dev/rmt/* ; devfsadm -v" to
repopulate /dev/rmt.
Bye
seb
Quoting Ty Young <phillip_young AT I2 DOT COM>:
All,
I just received the last part of our new bkup system, consisting of
2 x Sun T2000 servers (one as a NetWorker server, and one as a storage
node)
1 x StorageTek L500 library (4 x LTO3 drives)
1 x Brocade 4100 switch
2 x Sun/Emulex dual-port 4Gbit HBAs
The configuration we've chosen is to drive two tape drives with each
T2000, and hook the library robotics (also FC) onto the first HBA port.
The switch has been zoned this way and the drives and robotics are being
seen by the appropriate hosts.
My question is this. Shouldn't there be an entry in some sort
of /kernel/drv/*.conf file to bind the tape drives' WWNs to the HBAs?
I'm new to FC-connected drives, so I may not be asking an intelligent
question.
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the
body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
--
Sebastian Schönwetter
Open2 BVBA
Steenweg op Brussel 149
1780 Wemmel
Belgium
Tel : 0485 / 844 368
Fax : 02 / 460 39 86
BTW. nr : 866.285.026
Ond. nr : 0866285026
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu
if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|