Since even with NDMP backups, the NetApp continues to use the native
NetApp 'dump' command even though it is wrapped in a Legato savestream,
I can't see how it would support an 'incr'. However, using save levels
(9, 8, 7) work fine ( start high, go low for differentials, low then
high for incrementals).


--
Matthew Huff           | One Manhattanville Rd
Director of Operations | Purchase, NY 10577
OTA LLC                | Phone: 914-460-4039 
mailto:mhuff AT ox DOT com    | Fax:   914-460-4139   
-----Original Message-----
From: Legato NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU]
On Behalf Of Oscar Olsson
Sent: Monday, September 05, 2005 5:29 PM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] "incr" level save support in NDMP for 7.2.1?

So we made the leap and upgraded to 7.2.1 from 7.1.3. So far so good. We
have also ceased to use SnapImage, and we now use the built-in NDMP
support instead. That seems to work just fine. However, when I was
skimming through the docs and limitations of the NDMP chapter in the
administrators guide for 7.2, I didn't find any mention of that incr is
not a supported backup level when used with NetApp filers. Is this no
longer a limitation or did I just miss it it?

//Oscar

To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems wit this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or via RSS at
http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER

To sign off this list, send email to listserv AT listserv.temple DOT edu and 
type "signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu 
if you have any problems
wit this list. You can access the archives at 
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER