Re: [Networker] question on purpose of sji* commands
2005-06-16 11:40:48
That is Correct.
Sji commands are low level scsi commands.
I was told by legato at one point these commands are from the Bios of the
Tape lib.
Rgds
Venkat
-----Original Message-----
From: Legato NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU]
On
Behalf Of Ty Young
Sent: Thursday, June 16, 2005 10:01 AM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] question on purpose of sji* commands
All,
Can someone confirm for me that the purpose behind the sji* commands such
as
sjirdtag
sjirdelem
sjiinq
(under NetWorker 7.1.x and above) are to read the *jukebox* elements, as
opposed to what NetWorker thinks is in each one?
i.e. if I believe there's a discrepancy between the jb's inventory and what
nsrjb -C is telling me, I could use sjirdtag because this command actually
polls the jukebox itself. Is this correct?
Thx
-ty
Phillip T. ("Ty") Young, DMA
Manager, Data Center and Backup/Recovery Services
Information Services
i2 Technologies, Inc.
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listserv.temple DOT edu or visit the list's Web site at
http://listserv.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listserv.temple DOT edu or visit the list's Web site at
http://listserv.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
|
|