[Networker] Staging question...
2005-06-01 17:04:34
Hi...
I'm a newbie in regards to staging so I was wondering if you could
help.
We backup to disk and then plan to stage to tape. When an adv_file
backup disk device fills up, when would I expect
the staging to start? Is it based on the parameters set in the
customize/staging for high water , or which?
Today our adv_file device filled up 100%, and I did a 'start now'
for the 'stage all save sets' while the backup was running, but
nothing happened. I then stopped the backup and did a start now and
things are now staging.
How would this normally work? I.e. would I expect it to see high
water mark was exceeded during a file system check and THEN start
the staging?
Thanks in advance...
<>< ><> <>< ><> <>< ><> <>< ><> <>< ><> <><
Ken Kleiner
System Manager
Computer Science Department
Umass Lowell
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listserv.temple DOT edu or visit the list's Web site at
http://listserv.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Networker] Staging question...,
Ken Kleiner <=
|
|
|