I agree with Darren.
If you scanned in a tape, it is always in the state of "read only", afterwards.
regards
Klaus
> -----Ursprüngliche Nachricht-----
> Von: Legato NetWorker discussion
> [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] Im Auftrag von Darren Dunham
> Gesendet: Montag, 7. März 2005 17:21
> An: NETWORKER AT LISTSERV.TEMPLE DOT EDU
> Betreff: Re: [Networker] Using Pre-Labelled Tapes with single
> LTO Drive
>
>
> > After scanning the tapes they are always in state "write
> > protected". Is this normal or is my procedure flawed?
>
> I've only seen "write protected" as a reflection of the
> physical switch
> on the tape.
>
> The settings that Networker might use to avoid overwriting would be
> "full" or "read only", which are different from "write protected".
>
> --
> Darren Dunham
> ddunham AT taos DOT com
> Senior Technical Consultant TAOS
> http://www.taos.com/
> Got some Dr Pepper?
> San Francisco, CA bay area
> < This line left intentionally blank to confuse you. >
>
> --
> Note: To sign off this list, send a "signoff networker"
> command via email
> to listserv AT listserv.temple DOT edu or visit the list's Web site at
> http://listserv.temple.edu/archives/networker.html where you can
> also view and post messages to the list. Questions regarding this list
> should be sent to stan AT temple DOT edu
> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
>
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listserv.temple DOT edu or visit the list's Web site at
http://listserv.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|