I have NetWorker on Linux using an Adic FastStor DLT jukebox with a single
DLT7000 drive. NetWorker will move the tapes between the drive and the slots
just fine when I tell it to, however when it reaches the end of a tape
during a backup, it won't move it out of the drive and load the next one.



I have "Auto media management" set to yes in the jukebox config window,
which sounds like it should do what I'm asking for, but it doesn't.



Anyone have any ideas?



Thanks in advance,

Roy



Roy Kidder

Network Engineer

Safelite Glass Corp.




*************************************************************
This message, including any attachments, may contain
confidential information intended for a specific individual
and purpose, and may be protected by law.  If you are not
the intended recipient, please notify the sender by e-mail
or telephone immediately, and then immediately delete this
message.  Any disclosure, copying or distribution of this
message, or the taking of any action based on it, by any
unintended recipient is strictly prohibited.

Checked by the Safelite e-mail scanner which may have
resulted in the attachments being modified or removed.

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=