Yes, NMC 3.1 enables you to save report definitions, share them, and run the
reports from the command line. You can export in HTML, PDF, PS, and CSV. The
last being good for importing to spreadsheets. With NMC 3.0 you could
export, but you can't save a report definition or run from the command line.

NMC 3.11 also brings some enhancements to the admin GUI around being able to
create user groups, better device management, and also the ability to audit
any actions performed in NetWorker via NMC.


Shaun Ellis
LEGATO Software
3210, Porter Drive
Palo Alto
Ca 94304
Phone: +1 (650) 842 9548
Mobile: +1 (408) 431 6997


> -----Original Message-----
> From: owner-networker AT LISTMAIL.TEMPLE DOT EDU [mailto:owner-
> networker AT LISTMAIL.TEMPLE DOT EDU] On Behalf Of Ciolek, Ken
> Sent: Tuesday, August 24, 2004 11:11 AM
> To: NETWORKER (E-mail)
> Subject: Networker Management Console 3.0
>
> I want to start using the reporting feature included with NMC and want to
> export to a spreadsheet everyday with backup failures, etc. Has anyone
done
> anything like this? I heard you can only do the export with the new
version
> of NMC.
>
> --
> Note: To sign off this list, send a "signoff networker" command via email
> to listserv AT listmail.temple DOT edu or visit the list's Web site at
> http://listmail.temple.edu/archives/networker.html where you can
> also view and post messages to the list.
> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=